1.The cooling plate hydraulic cylinder is pressed from top to bottom to ensure thatthe cooling water will not enter the hydraulic system:the sink and the cart are made ofstainless steel, with a new 360 degree waterproof design, so that the cooling water will not fall on theground and outside the sink,making the workshop clean and tidy.;
2.Single-layer trolley with roller design, easy and effort-saving for mold in and out.
3.The frame is connected to the reservoir and the soft, reduce the level reguired for the installation site'
4.Cold plate innovative design, mold to direct flush cooling, and the cooling rate than ordinary cold shortening 1 times time, so higheryields;
5.Adopting PLC+multi language touch screen (including Vietnamese/indonesian languages);
6.Hydraulic system adopts logic loop operation, no oil seal configuration within the circuit, no wear leak worries;

Scope:EVA

EVAsole secondarymolding